250 CFM COMPRESSOR AFTERCOOLER GMP 89060 - Special Order
The 250CFM Compressor Aftercooler has been designed to cool compressed air and remove water droplets prior to entering a GMP Cable Blowing Machine.Features a heavy-duty moisture separator and coalescing filter to trap moisture and condensed oil.
FIBER OPTIC CABLE EZ-EXIT GMP 90060
The fiber optic cable EZ-Exit tool eliminates damage to your fiber by easily guiding fiber optic cable past the sharp edges of a manhole chimney. The easy clamping feature allows the tool to be quickly installed in less than 30 seconds, reducing the total setup time of a fiber pull. Provides a rigid, low friction shoe that guides fiber over the sharp edges at the top and bottom of a manhole chimney while maintaining a bend diameter of 45” to accommodate up to some of the largest fiber cables.
GMP 32800 Hydraulic Power Pack
GMP 89003 TORNADO
Designed to be safe, fast and effective, even on tough terrain, the "Tornado" cable blowing machine will move fiber optic cable of 0.23 to 1.25 in. (5.84-32 mm) diameter at speeds to 300 ft./min. (90 m/min.) into pre-installed innerduct or direct-buried duct. It can accommodate innerduct from .47 to 2.48 in. (12-63 mm). A conversion kit allows the Tornado to place 12.7/10mm, 12/10mm or 10/8mm micro duct into the innerduct.
GMP 89000 TORNADO CABLE BLOWING MACHINE
GMP 89003 TORNADO
Designed to be safe, fast and effective, even on tough terrain, the "Tornado" cable blowing machine will move fiber optic cable of 0.23 to 1.25 in. (5.84-32 mm) diameter at speeds to 300 ft./min. (90 m/min.) into pre-installed innerduct or direct-buried duct. It can accommodate innerduct from .47 to 2.48 in. (12-63 mm). A conversion kit allows the Tornado to place 12.7/10mm, 12/10mm or 10/8mm micro duct into the innerduct.
