You are here: Home > Condux Cable Tools > Fiber-optic Cable Pullers
We found 14 results matching your criteria.
Fiber-optic Cable Pullers
Sort By:
1
Condux 08030300 Plastic Line Carrier 4" Condux 08030300 Plastic Line Carrier 4"

Condux 08030300 Line Carrier 4", is a fast and efficient plastic carrier for fishing with high-speed blowers even in out-of-round duct and will travel over any minor obstruction that might be inside the duct.
Specifications:
Duct Size: 4" (102mm)
Maximum OD: 4.06" (103mm)

Condux 08675130 Mounting Socket Base Mount Condux 08675130 Mounting Socket Base Mount

The Condux Fiber Optic Cable Puller has a square mounting post 21⁄2" (64
mm) x 21⁄2" (64 mm). A female mounting socket  is required for
stability during cable pulling operations.

Condux 08675138 Mounting Socket Side Mount Condux 08675138 Mounting Socket Side Mount

The Condux Fiber Optic Cable Puller has a square mounting post 21⁄2" (64
mm) x 21⁄2" (64 mm). A female mounting socket  is required for
stability during cable pulling operations.

Condux 02260801 Mounting Socket Floor Mount, Cast Condux 02260801 Mounting Socket Floor Mount, Cast

The Condux Fiber Optic Cable Puller has a square mounting post 21⁄2" (64
mm) x 21⁄2" (64 mm). A female mounting socket  is required for
stability during cable pulling operations.

Our Price: $442.72
GMP 10727 Alloy Capstan  7" Alloy Capstan 7" GMP 10727

This general purpose capstan is used for a wide variety of pulling and hoisting applications. Cast from a high strength aluminum alloy for low weight . Will fit on any 2-7/16 in. (62 mm) diameter winch extension shaft equipped with a bayonet or pin type mount. The working surface is 7-1/4 in. diameter x 8 in. (184 mm x 200 mm) wide. The maximum allowable pull is 4000 lbs. (1814 kgs).

Our Price: $565.00
Condux 08675908 Fiber Optic Cable Puller Hitch Mount Condux 08675908 Fiber Optic Cable Puller Hitch Mount

The Condux 08675908 Fiber Optic Cable Puller Hitch Mount attaches directly into a typical 2" (51 mm)
square Reese-type receiver and the cable puller mounts in a 21⁄2" (64 mm) square fixture. An adjustable
jack is included for added stability and height adjustment. Pulling loads must not exceed 800 lbs. (3,559 N).

Condux 08675430 Capstan 30" x 8" Sheave Capstan Wheel 30" x 8" Condux 08675436

Condux Capstans are to conform to the many specifications to fiber optic cable available, and to offer more cable pulling capabilities. Diameter: 30" Flat With: 8" Max cable OD 1.25".



Condux 08760030-03 Slip Clutch 30" 300 lbs 300 lbs Capstan 30" Slip Clutch Condux 08760030-03

Slip Clutch Capstans from Condux are designed to mount directly on a bayonet style winch drive shaft. A factory preset torque limiter prevents pulling tensions from exceeding 300 pounds. If the preset load is reached, the capstan will "slip" and discontinue rotating. High strength aluminum and steel construction ensures product durability and cable protection.

Our Price: $4,387.50
Condux 08760030-04 Slip Clutch 30" 400 lbs 400 lbs Capstan 30" Slip Clutch Condux 08760030-04

Slip Clutch Capstans from Condux are designed to mount directly on a bayonet style winch drive shaft. A factory preset torque limiter prevents pulling tensions from exceeding 400 pounds. If the preset load is reached, the capstan will "slip" and discontinue rotating. High strength aluminum and steel construction ensures product durability and cable protection.

Our Price: $4,387.50
Condux 08675700 Portable Hydraulic Power Pack 9HP (5.9 GPM @ 1800 PSI) Condux 08675700 Portable Hydraulic Power Pack 9HP (5.9 GPM @ 1800 PSI)

Condux 08675700 Portable Hydraulic Power Pack 9HP (5.9 GPM @ 1800 PSI)
These portable power sources are matched perfectly to the power requirements of the Condux Fiber Optic Cable Puller and the Fiber Optic Cable Blower. Power source is a 9 HP (6.7 kW) Honda (gas), or a 16 HP (11.9 kW) Briggs & Stratton V-Twin Vanguard (gas) engine. Features electric start, large capacity hydraulic cooler, quick disconnects, low oil shut-off and 16" (406 mm) diameter pneumatic tires.
Specification:

  • Hydraulic System: Open Center
  • Frame Type: Two Wheel Mobile unit
  • Length: 26.5" (673 mm)
  • Width: 20.00" (508 mm)
  • Height: 27.5" (698 mm)
  • Weight: 143 lbs. (64.9 kg)
  • Filtration: 10 Micron Return Line Canister Type
  • Oil Cooler: Air to Oil
  • Engine: Gas, Honda, 9 HP (6.7 kW) @ 3,600 RPM
  • Fuel: 1.6 gallons/18.9 liters
  • Hydraulic Oil: 5.0 gallons/18.9 liters
Hydraulic Rated Flow:
  • 6.8 (GPM) - 0 (PSI)
  • 5.9 (GPM) - 1,800 (PSI)
  • 25.8 (LP) - 0 (BAR)
  • 22.4 (GPM) - 125 (BAR)

Our Price: $6,350.00
CONDUX 08675702 PORTABLE HYDRAULIC POWER PACK 13HP 13HP PORTABLE HYDRAULIC POWER PACK CONDUX 08675702

This portable power source is matched perfectly to the requirements for the Condux Fiber Optic Cable Blower and Puller. Utilizing a small footprint, the 13hp Power Pack features a variable flow switch (from 5gpm to 8gpm) to ensure that every job can be covered with just one machine.

Condux 08690001 Fiber Optic Cable Puller Package 1 (NO CAPSTAN) Fiber Optic Cable Puller Package 1 (NO CAPSTAN WHEEL) Condux 08690002

Condux Fiber Optic Cable Pullers consist of a hydraulic motor, variable speed foot control,
manual flow control valve for adjusting maximum speed and a manually adjustable pressure
relief valve for adjusting the ultimate pull tension. Does not include digital readout.

Condux 08690055 Fiber Optic Cable Puller Package 3 ( NO CAPSTAN) Fiber Optic Cable Puller Package 3 W/Chart Recorder( NO CAPSTAN) Condux 08690055

The Condux 08690055 Fiber Optic Cable Pullers W/ Chart Recorder Includes digital readout. consist of a hydraulic motor, variable
speed foot control, manual flow control valve for adjusting maximum speed and a manually
adjustable pressure relief valve for adjusting the ultimate pull tension.

Our Price: $16,985.21
Condux 08773501 APS75 Underground Cable Puller Trailer lbs. Condux 08773501 APS75 Underground Cable Puller Trailer 7500 lbs.

* Please call for freight quote *

Provides up to 7,500 lbs. of continuous pulling applications. Designed for installing underground cable, the APS75 is completely self contained and transport easily from job-site to job-site. This trailer is made with precision manufacturing, to the highest standards. Each puller is backed with years of underground cable pulling experience and a commitment to quality service.
Features:

  • Comes standard with 2600 ft. of Anti-twist Rope
  • Digital Monitoring System with USB connection to record & download pulling operations
  • Rotating Pulling Arm pivots 15 degrees in either direction
  • Wired Remote Control
  • Hydraulic tool circuit to operate additional tools
  • Easy access diesel engine for maintenance
  • Electric brakes
  • Numerous adjustable supports for optimum stability
  • DOT Certified Trailer
Advantages:
  • Nylatron Rollers have a super hard surface & last longer than conventional cast rollers
  • Easy to read Electronic Control Panel
  • Harden surface rollers
  • Dynamo-meter integrated in the puller
  • Controlled pay-in and out offer more operator safety
  • Smooth pull operation
  • Self contained trailer reduces noise
  • Low center of gravity
  • Excellent F/R weight

Our Price: $91,855.67
   
 
1