This portable power source is matched perfectly to the requirements for the Condux Fiber Optic Cable Blower and Puller. Utilizing a small footprint, the 13hp Power Pack features a variable flow switch (from 5gpm to 8gpm) to ensure that every job can be covered with just one machine.

Condux 08675700 Portable Hydraulic Power Pack 9HP (5.9 GPM @ 1800 PSI)
These portable power sources are matched perfectly to the power requirements of the Condux Fiber Optic Cable Puller and the Fiber Optic Cable Blower. Power source is a 9 HP (6.7 kW) Honda (gas), or a 16 HP (11.9 kW) Briggs & Stratton V-Twin Vanguard (gas) engine. Features electric start, large capacity hydraulic cooler, quick disconnects, low oil shut-off and 16" (406 mm) diameter pneumatic tires.

*USE WITH TIIGER POLE PULLER*
Full reversing control. The Cube is equipped with a commercial grade gasoline engine for years of trouble free service and all terrain pneumatic tires for easy portability.10" All terrain pneumatic tires for easy portability on most surfaces. 3/4 Inch steel handle for lasting durability and quality. 1 1/2 Gallon hydraulic fluid reservoir, 1" steel tubing frame and a 4 way/ 3 position manual valve with relief. pole puller, Tiiger hydraulic utility pole puller, pole pulling equipment

Tiiger Cube Pump TII-HB006-THE-CUBE-I

The C-71-5H Earth Drill is the work-horse of the Ground Hog line, tried and tested for over 30 years. Also known as an " Anchor Drill". This is a two man drill. Auger Bits sold separately.

The QP3TH is perfect for many pumping applications from dewatering to water tank and water truck use. Dual discharge ports increase the productivity and practicality of this gasoline-powered trash pump.

Multiquip QP3TH Trash Pump 7.9HP Honda, GX240 Gas Engine 3" Suction. Gas powered trash pump.
Hoses/Fittings sold seperately.

This Honda-powered trash pump boasts a host of standard features for superior performance across the board. One-man operation to use in various dewatering applications when you have debris in the water. Gas powered water pump

Multiquip 2" Suction, Trash Pump, GX160T QP2TH 211 GPM, 98 ft. MAX Head; Honda GX160
Gas powered Trash Pump
Hoses/fittings sold separately

The AMT Submersible 12 Volt DC pump is designed for use in dewatering applications where limited or no electricity is present and for emergency back-up during power failure.

Echo EDR-260 Gas Powered Reversible Drill

Engine Displacement (cc): 25.4; Torque (ft lb) 12; Carburetor: Butterfly-Valve Diaphragm; Maximum Chuck Diameter: 1/2 Standard; Fuel Capacity (fl. oz.): 14; Gear Reduction Ratio: 17:1:1; RPM: 0-650 Forward/Reverse; Consumer Warranty 5 years; Commercial Warranty: 2 years

This drill is no longer manufactured. We also have another model drill available: Echo EDR-260 Gas Powered Reversible Drill

Tanaka Gas Powered Reversible Drill 270PFR, 26.9 cc 1.4 hp PureFire® two-stroke engine meets emissions levels without sacrificing power, adding weight, or creating maintenance headaches.

ECHO PPT-2620 Gas Powered Pole Saw 12" Bar

25.4 cc professional-grade two-stroke engine manufactured from magnesium, Automatic, adjustable oiler to match cutting conditions Easy start-ability especially for re-starts in hot, dusty climates, Large 20.6 fluid ounce fuel tank for extended run time between fill-ups, Over-molded rear hand grip for extreme comfort, Ribbed fiberglass outer shaft for rigidity and control, Tool-less access for convenient in-field servicing, Two-stage air filtration system dramatically increases cleaning capability and allows for longer maintenance interval.

Without bar and chain

ECHO CS-590-20 Timber Wolf Chainsaw 20" Bar

Engine Displacement (cc): 59.8 ; Engine Displacement (cu in): 3.64 ; Starting System: Standard ; Sprocket Cover: Plastic ; Ignition System: Digital ; Carburetor: Butterfly-Valve Diaphragm (without purge pump) ; Sprocket Type: Spur ; Oiling System: Automatic/Adjustable (Clutch-Driven) ; Handle: Plastic ; Vibration Reduction System: Standard ; Fuel Capacity (fl. oz.): 21.8

The Ground Hog SD12 Standard Auger has a standard-style digging head for loose/sandy soil condition. This 12" Auger uses a screw-in fishtail centered pilot and bolt-on wide flat, hardfaced, standard side blades. All Ground Hog Augers are approximately
38"(3') in length and utilize a 7/8" standard square drive for interchangeability between Earth Drills.
Feature:

• Part #100 Fishtail Pilot(1)
• Part #912 Side Blade Installed(1)
• Part #1300 Attachment Pin & Clips(1)
• 7//8" Square Drive for interchangeability
• Durable Powder-Coated Finished
• 12" hole diameter

This portable 2-inch (50 mm) submersible pump is best for removing water from confined areas. One of the most popular sizes, the ST2040T can be used in many applications where debris will be found in the water. Great for use in sumps.

The Ground Hog PSD8 Pengo 8" Auger features heat treated cast alloy steel boring heads with hardened forged steel side blades and a bolt-on cast alloy steel centered pilot bit. The Pengo Series augers are general purpose augers and are the best choice for tough soil conditions. All Ground Hog Augers are approximately 38"(3') in length and utilize a 7/8" standard square drive for interchangeability between Earth Drills.
Features:

• Part # SB-25 Pilot Bit(1)
• Part # 35 Side Blades Installed(2)
• Part # 1300 Attachment Pin & Chip
• 8" hole diameter
• 7//8" Square Drive for interchangeability
• Screw-in hardfaced alloy steel pilot bit
• Durable Powder-Coated Finish
• Replaceable Forged Steel Side Blades

The Ground Hog SD12 Standard Auger has a standard-style digging head for loose/sandy soil condition. This 12" Auger uses a screw-in fishtail centered pilot and bolt-on wide flat, hardfaced, standard side blades. All Ground Hog Augers are approximately
38"(3') in length and utilize a 7/8" standard square drive for interchangeability between Earth Drills.
Feature:

• Part #100 Fishtail Pilot(1)
• Part #912 Side Blade Installed(1)
• Part #1300 Attachment Pin & Clips(1)
• 7//8" Square Drive for interchangeability
• Durable Powder-Coated Finished
• 12" hole diameter

The fiberglass chainsaw scabbard is designed to store your gas-powered or hydraulic chainsaw from your aerial basket by mounting to the inside of the bucket. Storage chamber is 6″ x 3 1/4″ x 17 1/2″

50 FOOT HOSE
DISCHARGE HOSE W/CAM LOCK MALE END & FEMALE END
INCLUDED HOF3246-PDB3X50 CXE AL E/E

50 FOOT HOSE
DISCHARGE HOSE W/CAM LOCK MALE END & FEMALE END
INCLUDED

25 FOOT HOSE
DISCHARGE HOSE W/CAM LOCK MALE END & FEMALE END
INCLUDED HOF3246-PDB3X25 CXE AL E/E

COUPLED MNPT X MNPT
2" SUCTION HOSE AND SCREEN 15'

25 FOOT HOSE
DISCHARGE HOSE W/CAM LOCK MALE END & FEMALE END
INCLUDED HOF3246-PDB2X25 CXE AL E/E

50 FOOT HOSE
DISCHARGE HOSE W/CAM LOCK MALE END & FEMALE END
INCLUDED HOF3246-PDB2X25 CXE AL E/E

Dewatering Sock - 10 oz. 1.5 ft. x 5 ft PUMPING SOCK
Also known as a sediment sock or pumping sock.

Replacement gas cap for the Tanaka TBC-2510 Grass Trimmer.

Female Camlock w/latches FemaleThread
Type D
SHORT SCREW ON ALUMINUM COUPLER

Male Camlock Male Threads
Type F
SHORT SCREW ON ALUMINUM COUPLER

Male Camlock Female Threads
Type A
SHORT SCREW ON ALUMINUM COUPLER