The fiber optic cable EZ-Exit tool eliminates damage to your fiber by easily guiding fiber optic cable past the sharp edges of a manhole chimney. The easy clamping feature allows the tool to be quickly installed in less than 30 seconds, reducing the total setup time of a fiber pull. Provides a rigid, low friction shoe that guides fiber over the sharp edges at the top and bottom of a manhole chimney while maintaining a bend diameter of 45” to accommodate up to some of the largest fiber cables.

• Small but powerful fiber blowing machine, which can blow both blown fibre (EPFU) and micro/nano cables. Tested in accordance to IEC standards.
• Fiber/Cable OD: 0.8-4.5 mm
• Duct size OD: 3.0-12.7 mm
• Preparation time: 3 min
• Blowing distance: up to 3,940 feet

DUCTROD RAPID
Designed to push a duct rod into an underground duct. It is equipped with a flexible clamping unit, allowing you to attach the machine to the sidewall of the manhole securing more stable installation.

• Fiber/Cable OD: 9-25 mm
• Duct size OD: 10-40 mm
• Preparation time: 2-4 min
• Blowing distance: up to 500 feet

• Tool free installation

• Adjustable Torque Distance and Speed
• measurement for complete rod control

• Easy to operate and designed for rough conditions. This hydraulic machine can blow a large variety of larger cables, fibers and ducts.
• Fiber/Cable OD: 5.5-25 mm
• Duct size OD: 10-63 mm
• Preparation time: 8-10 min
• Blowing distance: up to 16,404 feet
• Floating distance (with water): up to 32,808 feet

• Designed for RELINING of multiple micro ducts, but it can also be operated for SINGLE CABLES
• Fiber/Cable OD: 5.5-32 mm
• Duct size OD: 10-63 mm
• Preparation time: 8-10 min
• Blowing distance: up to 16,404 feet
• Floating distance (with water):up to 32,808 feet