The 250CFM Compressor Aftercooler has been designed to cool compressed air and remove water droplets prior to entering a GMP Cable Blowing Machine.Features a heavy-duty moisture separator and coalescing filter to trap moisture and condensed oil.

GMP Tornado Cable Blowing Duct Seals
Note: Cables 10.5mm and larger utilize the standard belt. Cables below 10.5mm require a dedicated belt.
DUCT SEALS (O.D. Controlled)

GMP Tornado Cable Blowing, Cable Guides
Always use a Cable Collet on the cable exit side. If you use either 6-9 mm or 9-12 mm cable, use a Cable Guide on the cable in feed side, for anything larger than these sizes.
CABLE COLLETS (6-34 MM) & GUIDES (6-12 MM)

In order to customize your new "Air Stream" to your application, we ask that you pick, one each from the lists below, the Tube Collet and Clamp Assembly P/N, the Cable Guide Assembly P/N and the Cable Collet Assembly P/N.
TUBE COLLET AND CLAMP ASSEMBLIES

GMP Tornado Cable Blowing Duct Clamps
Cables 10.5mm and larger utilize the standard belt. Cables below 10.5mm require a dedicated belt.
DUCT CLAMPS (O.D. Controlled)

In order to configure your JetStream to work with your specific cable requirements you must select items below that match your duct and cable size
CABLE SEALS (6-28 MM)

GMP CABLE SEALS PLUGS (6-34mm) 10/PK
Select the Cable Seals that match your cable size.

GMP 74099, Brass Cable Guiding Heads, are screwed on to the end of the cable to reduce friction during cable blowing. these bullet heads are constructed of corrosion resistant brass and made for repeated use.
Size OD: 7mm (0.28")

GMP 74097, Brass Cable Guiding Heads, are screwed on to the end of the cable to reduce friction during cable blowing. these bullet heads are constructed of corrosion resistant brass and made for repeated use.
Size OD: 6mm (0.24")

In order to customize your new "Air Stream" to your application, we ask that you pick, one each from the lists below, the Tube Collet and Clamp Assembly P/N, the Cable Guide Assembly P/N and the Cable Collet Assembly P/N.
CABLE GUIDE ASSEMBLIES

In order to customize your new "Air Stream" to your application, we ask that you pick, one each from the lists below, the Tube Collet and Clamp Assembly P/N, the Cable Guide Assembly P/N and the Cable Collet Assembly P/N.
SPARE CABLE SEAL (5 Pack)

In order to configure your Tornado to work with your specific cable requirements you must select items below that match your duct and cable size.
CABLE SEAL PLUGS (6-34 MM)

In order to customize your new "Air Stream" to your application, we ask that you pick, one each from the lists below, the Tube Collet and Clamp Assembly P/N, the Cable Guide Assembly P/N and the Cable Collet Assembly P/N.
SPARE TUBE SEAL O RING (5 Pack)